afasttest

Why does my Wi-Fi keep disconnecting?

8 min read · Updated November 20, 2026

Wi-Fi that keeps dropping usually comes down to a handful of causes. The first job is to work out whether the Wi-Fi is dropping or the internet behind it, and that takes about two minutes.

First: is it the Wi-Fi or the internet?

“My Wi-Fi keeps disconnecting” covers two different failures. Either your device loses its connection to the router, or the device stays connected but the internet behind the router stops working. The fixes are completely different, so check these the next time it happens:

  1. Look at the Wi-Fi icon. If it disappears or shows the device reconnecting, that’s a Wi-Fi drop. If it stays connected but warns of no internet, the problem is beyond the Wi-Fi: the router, modem or line.
  2. Check another device. If only one device drops, the cause is that device. If every Wi-Fi device drops together, it’s the router or the line.
  3. Check a wired device if you have one, such as a desktop, console or TV on Ethernet. If it loses internet too, Wi-Fi isn’t the problem.
  4. Look at the modem or gateway lights during a drop. A blinking or amber online, internet or DSL light means the connection to your provider went down.
  5. Open the router’s admin page (the address on its label). If the router responds but websites don’t, your home network is fine and the line is the problem.
What you seeWhere the problem isStart with
One device drops, others are fineThat devicePower saving, driver, forget and rejoin the network
All Wi-Fi devices drop, wired stays upRouter or Wi-Fi environmentRestart, channel, firmware, heat
Wired and Wi-Fi drop togetherModem or provider’s lineModem lights and log, cables, ISP
Drops only in certain roomsSignal strengthRouter placement, mesh node or access point
Drops when moving around the homeBand steering or mesh handoffSeparate band names, node placement
Connected, but no internet for seconds at a timeLine or modemPing and packet loss tests during the drop

Weak signal and interference

Edge of range is the most common cause. At the fringe of coverage, the signal drifts in and out as doors close and people move, and your device gives up and reconnects. If drops happen in particular rooms, that’s your answer: move the router toward the middle of the home, add a mesh node or access point, or move the device closer. Our guide on improving your Wi-Fi signal covers each option.

Interference and channel congestion cause drops even close to the router. On the crowded 2.4 GHz band, a running microwave oven or a dozen neighboring networks on the same channel can knock devices off. Choose the least crowded of channels 1, 6 and 11 on 2.4 GHz, and move devices that support it to 5 GHz.

DFS channels are a special case on 5 GHz. A router using one of these radar-shared channels (52 to 144 in the US) must switch away if it detects radar, and the switch can disconnect everyone for a short time. If your drops are random and brief and your router sits on one of these channels, pick a non-DFS channel such as 36–48 or 149–165.

Power-saving settings on laptops and phones

If one device drops while the rest of the house is fine, power management is the first suspect. Devices turn their Wi-Fi radio down or off to save battery, and some do it too eagerly, especially when the screen is off or the device has been idle.

  • Windows: open Device Manager, expand Network adapters, open your wireless adapter’s Properties, and on the Power Management tab untick “Allow the computer to turn off this device to save power”. Then, if your PC’s advanced Power Options show Wireless Adapter Settings, set Power Saving Mode to Maximum Performance.
  • Mac: install macOS updates, since Wi-Fi fixes often arrive that way. If the problem started after a router change, remove the network from the Mac’s list of known networks and join it again.
  • Phones: battery saver modes can limit Wi-Fi activity in the background. Also look for a setting that switches to mobile data when Wi-Fi is weak; it goes by different names on different phones. It can make a phone look as if it keeps leaving Wi-Fi when it’s choosing to.
  • Private or random hardware addresses: phones and computers can use a different MAC address for each network, or change it over time. That’s good for privacy, but it can confuse routers that use MAC filtering or address reservations. If one device keeps failing on such a network, turn the feature off for that network only.

Drivers, firmware and a router that needs a break

Outdated drivers or firmware cause many unexplained drops. On a Windows PC, get the latest wireless driver from the laptop or adapter maker’s support page rather than relying only on Windows Update. On the router, install firmware updates from its app or admin page; they often fix exactly this kind of instability.

A router that needs a restart gives itself away when drops become more frequent the longer it has been on, and a restart fixes them for a while. Restart the modem and router together; how to restart your router and modem shows the right order.

Overheating looks similar but tends to be worse on hot days or under heavy use. A router shut in a cabinet, stacked on other electronics or sitting in direct sun can crash or reboot itself. Give it space and airflow. A router that feels hot and keeps rebooting may be failing.

IP conflicts, band steering and mesh handoffs

IP address conflicts. Your router hands each device a local address using DHCP. If two devices end up with the same address, usually because one was given a fixed (static) IP inside the router’s range, they knock each other off, and Windows may show an IP conflict warning. Set devices back to obtain an address automatically, and reserve fixed addresses in the router instead of on the device.

A full address pool. Some routers hand out a limited range, such as 50 addresses. In a home full of phones, smart plugs and cameras, a new device can fail to get an address at all, and devices that rotate their MAC address can use up extra leases. Widening the DHCP range in the router’s settings fixes it.

Band steering. When 2.4 GHz and 5 GHz share one network name, the router nudges devices between bands. Some devices, especially older laptops and smart-home gadgets, handle the switch badly and drop. Test by giving the bands separate names; if the drops stop, keep them separate or put the troublesome devices on the 2.4 GHz name.

Mesh handoffs. In a mesh system, devices move between nodes as you walk around. A node placed too far from the others has a weak link, and devices bounce between nodes. Keep nodes within good range of each other, use a wired link between them if you can, and keep the mesh firmware updated.

Security settings. Some older devices struggle with WPA3 or mixed WPA2/WPA3 modes. If an old device started dropping after a router change, check the router’s security mode before replacing anything.

Too many devices, or the line itself

Too many devices. Every connected device takes some airtime, and dozens of phones, cameras and smart-home gadgets can push an older or budget router past what it handles well. The symptom is drops and slowdowns that get worse in the evening, when everyone is home. Wiring stationary devices such as TVs and consoles frees airtime, and Wi-Fi 6 and later routers handle crowds better.

Line drops. If wired devices lose internet at the same moments as Wi-Fi devices, the Wi-Fi is innocent. Check:

  • The modem lights during a drop. A blinking online or internet light means the modem lost its connection to your provider.
  • The modem’s log. Many cable modems have a status page, often at 192.168.100.1, showing signal levels and an event log. Repeated T3 or T4 timeout entries often point to a signal problem on the line.
  • Cables and connectors. Hand-tighten coax connectors and remove splitters you don’t need. On DSL, make sure every phone or other device on the line has a filter, unless your wall socket has one built in. On fiber, a red or unlit signal light on the box where the fiber enters usually means no signal from outside.
  • Your provider’s status page, then support, with the date and time of each drop.

Catch the drop while it’s happening

Intermittent problems are hard to diagnose afterwards, so test while they’re happening.

  1. Keep the ping test open on a device that’s having trouble, and run it as soon as things start to stutter. Jitter or ping far above your usual numbers shows the connection is struggling, even before it fully drops.
  2. Run the packet loss test during a bad patch. It sends steady, modest traffic for about 15 seconds and reports the share of packets that had to be resent on the way to you. A healthy connection shows close to 0%; a few percent means something along the path is losing data.
  3. Repeat on a wired device at the same time. Loss on Wi-Fi only points at the radio link; loss on both points at the modem or the line.
  4. Note the time of each drop. A pattern, such as every evening, every few hours or whenever the microwave runs, is often the clue, and a list of times is the evidence your ISP needs.

Both tests run in your browser, and your results never leave your device, so you can run them as often as you like.

Common questions

Why does my Wi-Fi keep disconnecting on my laptop only?

Usually power management or the network driver. Turn off power saving for the wireless adapter, update the driver from the maker’s site, and forget and rejoin the network.

Why is my Wi-Fi connected but not working?

Connected with no internet means your device reached the router, but the router can’t reach the internet. Check the modem lights, restart the modem and router, and test a wired device; if that fails too, it’s the line or an outage.

Why does my Wi-Fi keep dropping at night?

Evenings bring more of your own devices online and more neighbors onto the same channels, and some routers struggle under that load. Very late at night, scheduled router restarts, automatic firmware updates or provider maintenance can also cause short drops.

Why does my phone keep disconnecting from Wi-Fi?

Phones drop Wi-Fi when the signal is weak, when battery saver limits background activity, or when a setting switches them to mobile data. Check those settings, and forget and rejoin the network if the problem started after a router change.

Can a router go bad?

Yes. Failing power supplies, heat and aging components cause random reboots and drops. If the drops continue after a restart, a firmware update and better ventilation, replacing the router is reasonable.

How do I know if my ISP is causing the drops?

If wired devices drop at the same moments as Wi-Fi devices, or the modem’s online light blinks during drops, the problem is upstream of your router. Log the times and run the packet loss test during bad patches as evidence.

Related guides